Building - Dremel 3D40-EDU Operating/Safety Instructions Manual

Find Quality Products Online at:
CONNECTING USB CABLE
1. Ensure 3D40 power switch is in the off
position.
2. Connect the included USB cable to your
3D40 and computer, figure 5.
3. Open software.
4. Turn your Dremel 3D40 on using the
power switch to sync your computer to
your Dremel 3D40.
CONNECTING ETHERNET
1. Ensure 3D40 power switch is in the off
position.
2. Plug ethernet cable into your 3D40,
figure 6.
3. Turn your Dremel 3D40 on using the
power switch. Ethernet connection should
be detected automatically. Tap "Accept" to
confirm connection.
Observe all
WARNING
!
warnings and
instructions when using the Dremel 3D40.
Failure to do so may result in fire, equipment
damage, property damage or personal injury.
Do not reach inside the
WARNING
!
Dremel 3D40 while it is in
operation. Contact with Dremel 3D40 moving
parts during operation may result in poor build
quality, equipment damage or personal injury.
NOTE: Your Dremel 3D40 will build test
objects before leaving the factory. These test
objects may have been made with a different
filament color than you are using. Therefore,
GlobalTestSupply
www.
FIG. 5
FIG. 6

Building

provided a small amount of filament may be remaining
safety in the extruder. The start of your first object
may have some of this filament color until it
transitions over to your filament color.
You have several options when building on
your 3D40:
1) On-Printer Storage
2) USB Flash Drive
3) Online Print Queue
4) Computer
28
USB
Ethernet
.com
sales@GlobalTestSupply.com