Cooker; Extractor Hood; Heater/Boiler - Fiat Capron T58 Manual

15
Troubleshooting
15.5
15.6
15.7
142

Cooker

Fault
Ignition fuse does not
operate (flame does not
burn after the control
knobs are released)
Flame extinguishes when
being reduced to its
minimum setting

Extractor hood

Fault
Extractor hood does not
work
Extractor hood is not
working with full power
If the faults cannot be rectified using the table or the instruction manual, please
contact the customer service.

Heater/boiler

Fault
Heater does not ignite
Boiler empties, safety/
drainage valve has
opened
Safety/drainage valve
cannot be closed
Fan wheel runs noisily or
not steadily
None of the LEDs comes
on, device is switched
on, operating voltage is
connected
Cause
Heat-up time is too short
Ignition fuse is defective
Thermocouple sensor is
incorrectly set
Cause
Power supply is defective
Grease filter clogged
Active carbon filter
consumed
Cause
Temperature sensor on
operating unit or remote
sensor defective
Internal temperature
below 3 °C
Temperature at safety/
drainage valve below
8 °C
Fan wheel is soiled
Automatic restart is
blocked, e.g. following an
interruption of the power
supply
Remedy
Keep control knob
pressed for approx.
15 to 20 seconds after
ignition
Contact customer service
Correctly reset thermo-
couple sensor (do not
bend). The sensor tip
should protrude by 5 mm
beyond the burner. The
sensor neck should not
be more than 3 mm away
from the burner ring; if
necessary, contact
customer service
Remedy
Check fuse, replace if
necessary
Clean the grease filter
Change the active
carbon filter
Remedy
Pull out plug on operating
unit. The heater then
works without thermostat.
Contact the customer
service as soon as
possible
Heat inside
Heat inside
Contact Truma service
department
Reset the device (switch
off, wait 5 seconds,
switch on again)
EN
Capron - 04-17 - CAP-0017-01