Electrical Floor Warming Unit - Fiat Capron T58 Manual

10.2.8
Operating levels
Switching on:
Switching off:
Switching on overload
protection:
EN
Capron - 04-17 - CAP-0017-01

Electrical floor warming unit

On models with electrical floor warming unit, never drill holes in the floor
or screw in any screws. Careful with sharp objects. There is danger of a
power cut or a short circuit due to damage to a heater wire.
Do not cover the regulator. Danger of overheating!
The electrical floor warming unit only operates if the vehicle is connected
to the 240 V power supply.
The output of the electrical floor warming unit alone is not sufficient to heat
the living area.
The regulator for the electrical floor warming unit is located in the wardrobe.
The electrical floor warming unit has four operating levels:
0 "Off"
20 V "Low heating level"
22 V "Medium heating level"
24 V "High heating level"
Fig. 86 Regulator for electrical floor
warming unit
Connect the vehicle to the 240 V power supply (see section 9.6.1).
Turn the control knob (Fig. 86,2) to the required heating level.
Turn control knob (Fig. 86,2) to "0" position.
After switching off, the floor remains warm for a while, due to residual heat.
If the regulator is overloaded, the overload protection is actuated. The pin
(Fig. 86,1) jumps out.
Press the pin (Fig. 86,1) on the overload protection when the regulator is
cooled.
10
Appliances
99