Hot-Air Heater And Boiler With Cp Plus Digital Operating Unit - Fiat Capron T58 Manual

Summer operation
Switching production of hot
water on:
Switching production of hot
water off:
10.2.5
Operating unit
EN
Capron - 04-17 - CAP-0017-01
It is not possible to heat the vehicle in "Summer" operating mode. In this oper-
ating mode, only the domestic water is heated up to either 40 °C or 60 °C.
Open the regulator tap on the gas bottle and the gas isolator tap "Heater/
boiler".
Set the rotary switch (Fig. 80,6) on the operating unit (Fig. 80) to "Summer
operation" (Fig. 80,1 or 2).
The yellow indicator lamp (Fig. 80,9) is illuminated during the heating up
period. When the set water temperature is reached, the period of heating up
is finished and the yellow indicator lamp fades.
In case of fault, the indicator lamp (Fig. 80,9) on the operating unit glows red
(see section 15.7).
Set the rotary switch (Fig. 80,6) on the operating unit (Fig. 80) to " ".
Close the gas isolator tap "Heater/boiler" and the regulator tap on the gas
bottle.

Hot-air heater and boiler with CP plus digital operating unit

If there is a risk of frost and the heater is not in operation, empty the boiler.
The circulation fan is automatically switched on when the hot-air heater is
activated, and it stays on. This puts an immense strain on the living area
battery, if the vehicle is not connected to an external 240 V power supply.
Take into consideration that the living area battery only has limited
reserves of energy.
The hot-air heater can even run on an empty boiler.
If the power supply to the heater was interrupted, the time must be reset.
The operating unit is divided into two sections:
Display
Operating buttons
Fig. 81 Operating unit (hot-air heater
and boiler)
After being switched on, the most recently set values/operating parameters
are activated.
If no button is pressed, the operating unit switches to stand-by mode after a
few minutes.
If the time is set, the display in stand-by mode alternates between the time and
the room temperature set.
Appliances
1 Display
2 Rotary push button
3 Back button
10
93