Replacing Bulbs, Internal; Led Lamps - Fiat Capron T58 Manual

13
Maintenance
13.4
13.4.1
132
Fig. 122 Remove the cover
Insert the snap-in lugs of the supplied tool (Fig. 122,1) at the sides of the
cover as shown.
Remove the cover with the tool.
Change the bulb.
Applying light pressure, push the cover on the lamp until it snaps into place.

Replacing bulbs, internal

Bulbs and light fittings can be extremely hot. Therefore, allow lights to
cool down before changing bulbs.
Shut off the power supply on the safety cut-out in the 240 V fuse box
before changing bulbs.
Store bulbs in a safe place inaccessible to children.
Do not use any bulb that has been dropped or which shows scratches in
its glass. The bulb might burst.
Do not replace the LEDs in lights with standard light bulbs. Risk of fire
due to intense heat build up.
A new bulb should not be touched with the fingers. Use a cloth when
installing the new bulb.
Only use bulbs of the same type and with the correct wattage.
If LEDs in lights are defect, contact an authorised dealer or service centre.
The lights shown in this section are examples. Depending on the model,
the lights may differ from the the type displayed here. The examples are
intended to point out the possible procedures for changing bulbs in lights.

LED lamps

Fig. 123 LED ceiling lamp (example) Fig. 124 Recessed LED light (example)
Capron - 04-17 - CAP-0017-01
EN