Connection Of Other Accessories; (Commercially Available Parts) - Kenwood HM-982RW Instruction Manual

2. Connection of Other Accessories

When connections are to be made, make sure
that the power plug is not plugged into a wall AC
outlet. Connect the equipment as shown in the
figures.
Conection of Subwoofer (optional)
Extremely low frequency sound is played back powerfully.
R
DIGITAL IN OUT @ @ @IN
OPTICAL AUX
Connection of external source component
Analog signal connection
The AUX (OUT/IN) input jacks on the rear panel can be used to connect a cassette deck, etc.
R
DIGITAL IN OUT @ @ @IN
OPTICAL AUX
Digital signal connection
The OPTICAL digital input jack on the rear panel can be used to connect a digital component.
For the digital signals which can be recorded and played on this system, see "Sampling frequency".A
Be sure to retain the cap removed above.
R
DIGITAL IN OUT IN
OPTICAL AUX
The source connected to the DIGITAL IN OPTICAL jack cannot be recorded onto tape. To record an external source
on tape, connect the source component's output to the AUX IN jacks and select the "AUX" input source.
1.In case an associated system component is connected, also read the instruction manual of the component.
2.Insert the optical-fiber cable straight into the connector until it clicks.
Notes Notes
3.Be sure to attach the protection cap when the connector is not used.
4.Never bend or bundle the optical-fiber cable.
L
SUB WOOFER
SUB WOOFER
PRE OUT
PRE OUT
L
SUBWOOFER
OUT IN
PRE OUT
A U X
L
SUB WOOFER
DIGITAL IN
PRE OUT
OPTICAL

(Commercially Available Parts)

L
R
Optical fiber cable
System connection
Subwoofer
Cassette deck etc.
audio input
audio output
Digital component
Optical digital audio output
13
2 3
0 7
8
1 ¡
¶