Kenwood HM-982RW Instruction Manual page 6

6
Attaching the front door
1 Remove the protection cap from the bearing sec-
tion.
2 Fit the front door between two bearings by posi-
tioning the door at a position where it is opened by
more than 180° as shown below.
180º or more
'
3 Close the front door with a hand.
CAUTION
When you use the system without attaching the
front door, be sure to leave the protection cap
attached. If the system is used without the front
panel and protection cap, you may be injured by
contacting the metallic parts around the front door
bearing.
÷ Be sure to retain the removed protection cap.
÷ If the front door is not fully opened, a clearance is produced
at the lower bearing section, making it impossible to close
the front door.
÷ Be sure to close and open the front door with hand.
÷ When detaching the front door, open the front door by more
than 180º and lift it to disengage from the bearings.
When the system main unit and speakers are arranged side by side, leave
a certain space between the main unit and left speaker so that the opening
Note Note
and closing of the front door is not hindered.
gap
0 MICRO HI-FI-COMPONENT SYSTEM
0
Introduction