Kenwood HM-982RW Instruction Manual page 69

4
Start recording.
TWIN
REC
To interrupt a recording
Press the 7 (stop) key on the main unit or 7 STOP
key on the remote. (This stops both recording and
playback.)
Convenient recording of CD player output
÷ When the CD-R/RW does not have available recording time at
all or the tape has been wound till the end, recording cannot
be started.
÷ When the CD playback stops, other operations also stop
automatically.
÷ When you are operating the main unit, select "O.T.E. Mode"
in the menu mode then select "Twin Rec" and press the SET
key to start recording.
÷ When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
CDR
÷ With certain discs, digital-to-digital recording may be prohib-
ited by SCMS (A). Such a disc should be recorded using
the analog output signal.
÷ "CDR Writing" is displayed when recording completes.
Display "CDR Writing" indicates that recorded data
is being written in the CD-R/RW. Do not apply
vibrations or impact during recording and "CDR
Writing" display.
If the power cord is unplugged from the power
outlet or a power failure occurs during recording, the
disc data may be destroyed and the disc may be-
come unusable.
During digital-to-digital recording, the CD recorder
may encounter a track with which digital-to-digital
recording is prohibited. In this case, "SCMS"(A) is
displayed and recording pauses temporarily, but play-
back of the source continues and recording restarts
whenever a track with which digital-to-digital record-
ing is permitted is encountered. However, if "SCMS"
is displayed with the first track to be recorded, the
track as well as the subsequent tracks will not be
recorded.
To finalize the recorded CD-R/RW
69
e
∏