Sleep Timer (Sleep) - Kenwood HM-982RW Instruction Manual

To cancel execution of a timer program (Remote control unit only)
Press the TIMER key repeatedly until "PROG.1" or
"PROG.2" disappears.
TIMER
To set the same timer program again (Remote control unit only)
Press the TIMER key repeatedly until "PROG.1" or
"PROG.2" is displayed. To set both "PROG.1" and
"PROG.2", press the key so that "PROG.1 2" lights.
TIMER
÷ With timer recording, the audio is muted automatically at the moment the power is switched ON by the timer.
÷ The reservation contents cannot be cleared. The contents are cleared only when they are changed.
Note Note
÷ If the STANDBY/TIMER indicator blinks in green when the power is switched OFF (Standby), the timer will not be
executed.In this case, set the clock again.
÷ After the timer has been set and power is off (timer standby), if there is a power failure or the power cord is unplugged
from and plugged again into the power outlet, the STANDBY/TIMER indicator blinks in green. In this case, set the
clock again.

Sleep timer (SLEEP)

The sleep timer is used to set the period after which the power will switch OFF automatically.
Press the SLEEP key during CD(CD-R/RW) or TAPE
playback or during radio reception.
SLEEP
÷ Pressing the SLEEP key once allows you to check the
remaining time.
÷ The unit is turned OFF automatically after the set time has
elapsed.
The system has been set so that the display bright-
ness drops automatically during the sleep timer op-
eration. (Auto dimmer)
(Remote control unit only)
Goes off
PROG.
UN FINALIZE D
SKIP PLAY
÷ The reservation contents are held in memory.
Lights
PROG.
UN FINALIZE D
SKIP PLAY
F M P 0 1
÷ Also prepare the disc and adjust the listening volume.
÷ Each press increases the set time by 10 minutes. The sleep
timer can be set up to about 90 minutes.
10 =20=30 ....70 = 80= 90 = Cancel
S l e e p
1 0
SLEEP
To cancel
Turn the power OFF or press the SLEEP key until
the sleep time is cancelled.
79
Timer operation
£
(
(