Table of Contents
Advertisement
40
Recording on TAPE
This system can record signals on Normal (TYPE ) and High (TYPE ) position tapes. Remember that the Metal (TYPE
Note
Note
Note
cannot be used with this system.
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
In the direction of the arrow
23
TAPE
2
2
Pause the recording
6
6
Stop the recording
1. Load a tape in deck.
÷ Remove tape slack before loading.
Insert the cassette tape straight into the insertion slot. Just push lightly
and the cassette will be pulled automatically inside, and TAPE IN indi-
cator lights.
The cassette tape cannot be loaded or ejected while the unit is in
standby mode.
Do not force load a cassette tape in standby mode, otherwise malfunc-
tion will result.
2. Select the tape transport direction.
To reverse the transport direction
1 Press the TAPE 23 key.
2 Press the TAPE 23 key again.
3 Press the 7 STOP key to stop it.
÷
When recording is started, the tape is transported in the direction selected
in this step."Transport direction indicators"
÷
Wind the tape to the position where recording is to be started."To wind
tape at high speed"
3. Set the recording condition.
1 Select the reverse mode. ª
2 Select the Dolby NR mode.ª
Stop the recording
1
1
Recording on TAPE
) tapes
4
4
2
2
0
•
ª
Advertisement
Table of Contents
