Kenwood HM-982RW Instruction Manual page 45

3
Setting the automatic blank detection level (Cut Lv.)
The automatic blank detection level during analog-to-digital recording can be set by the user. If you do not
want to adjust it, simply press the SET key.
Even when the track number setting mode (T.Mark) is set to "Auto", the track numbers may not be
incremented if the level of blanks in the recording source are high. In this case, increase the blank detection
level.
On the contrary, if track numbers are incremented on other points than blanks, decrease the blank detection
level.
1 Adjust the automatic blank detection level using
the MULTI CONTROL keys.
MULTI
CONTROL
2 Complete the setting mode.
SET
Changing the recording input setting
÷ The blank detection level can be adjusted in the range from
-2 to +2.
+ ...... Increases the blank detection level.
– ...... Decreases the blank detection level.
C u t
L v . - 2
÷ Even when the blank detection level is adjusted, there may
be cases in which track number marking are not improved.
45
Recording on TAPE