Kenwood HM-982RW Instruction Manual page 29

To wind tape at high speed
22
TUNING
Transport direction indicators
Indicator Tape transport direction
3
Direction of insertion
into main unit \
2
Direction of insertion
into main unit \
÷ If you are operating the main unit, press the 4, ¢ key.
÷ Press the 7 STOP key to stop fast winding.
÷ The same function is also available using the 4, ¢ key
on the remote control unit.
To reduce tape noise (DOLBY NR)
Remote control unit only
The Dolby Noise Reduction system reduces inherent
noise to tape playback.
Set the Dolby NR according to the Dolby NR used
when recording each cassette tape.
DOLBY NR
Each press switch the modes as follows.
" NR" lit ................... Dolby NR is used.
" NR" goes off ......... Dolby NR is deactivated.
To stop playback
7
STOP
Ejecting the cassette tape
33
Fast Fast
reverse forward
1 ¡
(4) (¢)
¡ 1
(¢) (4)
0
TAPE IN
Selection of reverse mode (TAPE RVS.)
1 Press the MENU key.
2 Select "TAPE RVS. ?".
3 Select.
MULTI
CONTROL
1 REVERSE (
)
Both sides are played back (recorded), and then
the tape stops.
2 ENDLESS (
)
Both sides are played back endlessly.
(The tape stops after recording onto both sides.)
3 ONE WAY (
)
Only one side is played back (recorded), and
then the tape stops.
(The initial setting is "REVERSE".)
4 Set it.
When you are operating the remote, press the
REV.MODE key to change the reverse mode.
Notes Notes
÷When playback with the tape reverse mode of "
(REVERSE) is started in tape transport direction "2",
playback ends after having played only the side where it
was started.
÷When recording with the tape reverse mode of "
(REVERSE) is started in tape transport direction "2",
recording ends after having recorded only the side where
it was started.
÷When recording with the tape reverse mode of "
(ENDLESS) is started in tape transport direction "2",
recording ends after having recorded only the side where
it was started.
A tip for use of the tape counter
The tape counter is set to "0000" when a cassette tape is
loaded. By writing down the counter reading in case you
want to interrupt recording (playback) in the middle of
the tape, the memo will be helpful as a reference for lo-
cating the same position when continuing the recording
(playback) the next time. The tape counter figure decre-
ments during recording or playback of the back side (while
the 2 tape transport indicator is lit).
To reset the tape counter to "0000", eject the cassette
tape temporarily. This will reset the counter.
Playback of TAPE
SET
29
"
"
"