Table of Contents
Advertisement
USB Connections
All of the USB ports are compatible with the USB 2.0 and 1.1 specification. The four
USB ports on the front panel of the M9036A Controller (see graphic below) are USB
Series "A" ports. These are ports to which you can connect USB mass storage devices,
accessories such as printers and keyboards, and the E6618A Multiport Adapter. The test
set USB Host support includes the standard Microsoft Windows USB class drivers for
human interface, mass storage, printing, scanning, and imaging devices. A complete
up-to-date list of the Windows USB class driver support is available on the Microsoft
website.
http://www.microsoft.com/whdc/system/bus/usb/USBFAQ_intro.mspx
The test set USB device driver included in the test set software supports the test and
measurement industry standard USBTMC-USB488 device class.
In addition, the Agilent IO Libraries CD that was included with your test set contains
USB Host drivers that allow control of other test sets connected to the USB bus.
Agilent Technologies does not support or warrant correct test set operation if additional
USB drivers from third parties are installed in the test set. It is possible that additional
drivers could break the normal USB operation. If USB operation is broken, recovery
would require reinstalling the test set application using the hard drive recovery process.
Getting Started Guide
Test Set Operating System
3
63
Advertisement
Table of Contents
