Table of Contents
Advertisement
5
Troubleshooting
Check the Basics
o Is there power at the receptacle?
o Is the test set turned on? Check to see if the green LED beside the power switch is on.
o If other equipment, cables, and connectors are being used with your test set, make
o If the analyzer cannot completely load or run the operating system, or the instrument
o Is the Measurement Application running? If not, there is a software launch
o Does the test set application have the focus? (That is, is the blue window banner
o Review the measurement procedures being performed when the problem first
o If the test set is not functioning as expected, return the test set to a known state by
o Is the measurement being performed, and the results that are expected, within the
o If the test set is not communicating via the LAN connection, check for the presence
o To meet specifications, the test set must be aligned. Either the Auto Align (On)
o Perform an Alignment. Press
98
Also, listen for internal fan noise to determine if the test set cooling fans are running.
sure they are connected properly and operating correctly.
application is not successfully launched, the problem could be a corrupt hard drive. If
the analyzer gets far enough along in the boot process to run the "Agilent Recovery
System", perform the
"Hard Drive Recovery Process" on page
shortcut/icon on the desktop.
highlighted?) If not, move focus to the application with Alt-Tab.
appeared. Are all of the settings correct?
pressing
Mode Preset
.
Some test set settings are not affected by a Preset. If you wish to reset the
test set settings, press
specifications and capabilities of the test set? Refer to the specifications guide for
your test set. Technical manual pdf files are available in the test set (C:\Program
Files\Agilent\SignalAnalysis\Infrastructure\Help\files), on the documentations cd
provided with the test set, and on the Agilent website:
http://www.agilent.com/find/E6630A
of blinking yellow LEDs on the rear panel LAN connector. If the ACT LED is not
blinking, check the LAN cable and LAN integrity.
feature must be selected (press
test set must be manually aligned.
System
,
Power On
System
,
Alignments
,
,
,
System
Alignments
Align Now
65.
,
Restore Power On Defaults
Auto Align
,
Normal
), or the
,
.
All
Getting Started Guide
.
Advertisement
Table of Contents
