S7 F System - Getting Started; S7 F System, Setting Up The Hardware - Siemens SIMATIC S7 F Manual

Getting Started
2.2

S7 F System - Getting Started

2.2.1

S7 F System, Setting up the Hardware

The following figure shows you an example of a hardware configuration.
S7 F programmable
For this example, you need the following hardware components:
•
A programmable logic controller consisting of:
- 1 mounting rack (UR2-H)
- 1 power supply (PS 407 10A)
- 1 CPU 417-4H
•
An ET 200M distributed I/O device with an active backplane bus consisting of:
- 1 power supply (PS307 5A)
- 1 IM 153-2 Bus Interface Module
- 1 Safety Protector Module
- 1 fail-safe digital input module (SM 326F DI 24xDC24V)
- 1 fail-safe digital output module (SM 326F DO10xDC24V/2A)
•
Other accessories
- PROFIBUS cables and connectors
Set the DIL switches for the individual components as follows:
•
IM153-2 PROFIBUS address 3
•
SM 326F DI 24 Module address 8
(Only found on the reverse side; only in steps of 8)
•
SM 326F DO10 Module address 24
(Only found on the reverse side; only in steps of 8)
2-4
controller
Profibus DP Cable
Single-channel, one-sided
ET 200M Distributed I/O
Fail-safe
signal modules
Safety Protector
Module
Fail-Safe Systems
A5E00085588-03