Siemens SIMATIC S7 F Manual page 34

Product Overview
Scenario 3: Modifying or Creating Projects Based on Failsafe Blocks (V1_2)
Use this scenario if you wish to:
Modify or create projects based on Failsafe Blocks (V1_2) library contained in S7 F
Systems V5.2. You must have the minimum software requirements to allow this.
Software/Firmware Requirements
The following software packages must be installed on the PC/Programming
Device/Workstation in order to modify or create projects based on Failsafe Blocks
(V1_2) library:
•
S7 F Systems V5.2
•
STEP7 V5.2 or higher
•
S7 H Systems Optional Package V5.1 or higher (required for S7 FH Systems)
•
CFC V5.2.4
•
CPU S7-417F/FH V3.1 or higher
ET 200S fail-safe module drivers are available, but this requires CFC V6.0.
Procedure
There are no additional procedures beyond this.
1-18
Fail-Safe Systems
A5E00085588-03