Submenu For Thread Monitor Configuration - DURKOPP ADLER 540-100-1 Manual Complete

4.1.4 Submenu for the thread monitor configuration
No. Parameter name
T1.4.1 Repair mode
T1.4.2 Needle thread monitor
Symbol Range
A, B, C
0 ... 10
Description repair modes T1.4.1
Method A:
The buttonhole has to be unstitched and sewn again.
–
After switching the automate on again the sewing basket lifts and
releases the material.
The automate is ready for a new sewing cycle.
Method B:
The buttonhole is completely stitched around anew.
–
After switching the automate on again the sewing basket remains
lowered. The material under the sewing basket remains in its
position.
–
Step the pedal forward (2nd step). The sewing cycle is started.
–
After the sewing cycle the automate runs in reference position and
the sewing basket is lifted.
–
The material can be taken out.
The automate is ready for a new sewing cycle.
Method C:
The buttonhole is continued to be sewn from the recognized point of
thread breakage.
–
After switching the automate on again the sewing basket remains
lowered. The material under the sewing basket remains in its
position.
–
Step the pedal forward (2nd step). The sewing basket moves to the
recognized point of thread breakage with the material.
With the cursor keys ñ and ò you can move - not sewing - to the
–
position to continue the sewing cycle.
–
Step the pedal forward (2nd step). The sewing cycle is started.
–
After the sewing cycle the automate runs in reference position and
the sewing basket is lifted.
–
The material can be taken out.
The automate is ready for a new sewing cycle.
Description
Selection of the repair mode to be
used.
Number of stitches not registered by
the thread breakage monitor before
an error message is displayed.
At the value 0 the thread breakage
monitor is switched off.
3
9