O-Adjusting The Room Temperature Offset; P-Viewing Sensor Temperature - Traulsen G Series Owner's Manual

VII. o - ADJUSTING THE ROOM TEMPERATURE OFFSET:
The room temperature offset parameter allows a service technician or end user the ability to have the display show a tem-
perature that is within three degrees of the actual temperature being read by the cabinet air sensor. This allows for continuity
of reading between different temperature reading devices. (i.e.: thermistor Vs thermocouple Vs handheld thermometer) This
parameter is preset at the factory to "0" or no offset.
Follow the instructions to enter the customer access code on page 8. When the control displays
Set Point, press the down arrow key
the set button .
SET
display shows the offset you want press the set button
Offset. You can use the up or down arrow keys
control to return to normal operation.
VII. p - VIEWING SENSOR TEMPERATURES:
These parameters allow a service technician or customer to view the temperatures of all sensors within the unit. The tem
peratures cannot be adjusted. Follow the instructions to enter the customer access code on page 8. When the control
displays Thermostat Set Point, press the DOWN arrow key
Sensor or Cabinet Air
the SET button when done. Press the UP or DOWN arrow keys
SET
or wait 30 seconds for the control to return to normal operation.
VII. MICROPROCESSOR CONTROL (cont'd)
until the control display reads
Use the arrow keys
or press the SET button
to adjust the offset to your desired setting. When the
. The display will then read
SET
to scroll to the next parameter or wait 30 seconds for the
unit the display reads Evaporator Coil
SET
-15-
Room Temperature Offset. Press
Room Temperature
. To view the current sensor value press
to scroll through the parameters
Thermostat