J-Setting The 24-Hour Clock - Traulsen G Series Owner's Manual

VII. j - SETTING THE 24-HOUR CLOCK:
The internal timeclock must be set in order to allow any defrost lock out to occur at the correct time of day. If the clock is
not set, the control assumes the time is 12 a.m. at the time power is supplied to the unit. The hours on a 24-hour timeclock
read the following way:
H01 = 1:00 a.m. H07 = 7:00 a.m.
H02 = 2:00 a.m. H08 = 8:00 a.m.
H03 = 3:00 a.m. H09 = 9:00 a.m.
H04 = 4:00 a.m. H10 = 10:00 a.m.
H05 = 5:00 a.m. H11 = 11:00 a.m.
H06 = 6:00 a.m H12 = 12:00 p.m.
Follow the instructions to enter the customer access code on page 8. When the control
displays Thermostat Set Point, press the down arrow key
display reads
The display will show
Use the arrow keys
When the correct hour is displayed, press the set button
The display will show
Use the arrow keys to set the minutes
When the correct minutes are displayed, press the set button
The display will then read
You can use the up or down arrow keys
or wait 30 seconds for the control to return to normal operation.
VII. MICROPROCESSOR CONTROL (cont'd)
H13 = 1:00 p.m.
H14 = 2:00 p.m.
H15 = 3:00 p.m.
H16 = 4:00 p.m.
H17 = 5:00 p.m.
H18 = 6:00 p.m.
Clock. Press the set button
Hours. The right two numbers will be flashing.
to set the hour.
Minutes. The right two numbers will be flashing.
Clock.
H19 = 7:00 p.m.
H20 = 8:00 p.m.
H21 = 9:00 p.m.
H22 = 10:00 p.m.
H23 = 11:00 p.m.
H24 = 12:00 a.m.
until the control
.
SET
.
SET
.
.
SET
to scroll to the next parameter
-11-