D-Cleaning The Exterior; E-Cleaning The Interior; F-Adjusting The Shelves; Other - Traulsen G Series Owner's Manual

V. CARE & MAINTENANCE (cont'd)
V. d - CLEANING THE EXTERIOR:
Exterior stainless steel and aluminum should be cleaned
with warm water, mild soap and a soft cloth. Apply with
a dampened cloth and wipe in the direction of the metal
grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the surface.
Do NOT use cleansers containing chlorine, this may
promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with
water, containing chlorinated cleansers, when mopping
the floor around the unit.
For stubborn odor spills, use baking soda and water
(mixed to a 1 TBSP baking soda to 1 pint water ratio).
V. e - CLEANING THE INTERIOR:
For cleaning anodized aluminum interiors, the use of bak-
ing soda as described in section "V. d" is recommended.
Use on breaker strips as well as door gaskets. All interior
fittings are removable without tools to facilitate cleaning.
V. f - ADJUSTING THE SHELVES:
For shelves mounted on pins, first select the desired
location and remove the white plastic covers in the inte-
rior back and sides by rotating them counterclockwise.
Remove the shelf pins by rotating them counterclockwise.
Install the pins in the desired location by rotating clock-
wise. Make sure the pin is securely tightened down. Do
not over tighten. Slide the shelf into its new position, and
replace the white plastic covers into the holes vacated
by the shelf pins.
VI. OTHER
VI. a - SERVICE INFORMATION:
Before calling for service, please check the following:
Is the electrical cord plugged in?
Is the fuse OK or circuit breaker on?
Is the power switch "ON"?
If after checking the above items and the unit is still not
operating properly, please contact an authorized Traulsen
service agent. A complete list of authorized service agents
was provided along with your Traulsen unit. If you cannot
locate this, you may also obtain the name of a service
agent from the Tech Service page of our website: www.
traulsen.com.
VI. OTHER (cont'd)
VI. a - SERVICE INFORMATION (cont'd):
If service is not satisfactory, please contact our in-house service
department at: Traulsen
4401 Blue Mound Road
Fort Worth, TX 76106
(800) 825-8220
Traulsen reserves the right to change specifications or discontinue
models without notice.
VI. b - SPARE PARTS:
Spare or replacement parts may be obtained through a parts sup-
plier or one of our authorized service agents. A complete list of
authorized service agents accompanies this manual and is also
posted on our company's official website at www.traulsen.com.
VI. c - WARRANTY REGISTRATION:
The warranty for your new Traulsen unit may be registered with us
by completing the enclosed warranty card (shipped with the unit),
registering on-line or calling us direct at 800-825-8220.
VII. MICROPROCESSOR CONTROL
°F
REFRIGERA-
REFRIGERATOR
Your new Traulsen G-Series Refrigerator or Freezer is equipped
with an electronic microprocessor control, which precisely regu-
lates operation. It is supplied from the factory completely ready
for use. See pages 6 thru 15 for more information.
VIII. a - MICROPROCESSOR CONTROL FEATURES:
Internal Time Clock
• Eliminates defrost time clock (refrigerator and freezer models
only).
• See "Setting The 24-Hour Clock" on Page 11. (Also required at
"Start Up")
• Will automatically update for Daylight Savings Time. See "Set
ting Daylight Savings Time" on page 12.
-6-
°C
SET
FREEZER