Siemens 6DR55 Series Manual page 86

Preparing for operation
.
84
4. Switch to the second parameter by pressing the operation mode
key briefly.
Display:
NOTE
Make sure that the transmission ratio selector is in position 90 °!
5. Switch on to the following display by pressing the operation mode
key twice:
The following steps are identical with the steps 6) to 9) for
initialization of linear actuators.
After successful initialization the determined part--turn range
appears in the top display.
"5.INITM" appears in the bottom line again after pressing the
operation mode key
Configuration operating mode.
To exit the Configuration mode, press the operation mode key
for longer than 5 seconds. The software version is displayed after
about 5 seconds. The instrument is in manual operation after
releasing the operation mode key.
briefly. This brings you back to the
SIPART PS2 PA Manual
A5E00127926--05