Table of Contents
Advertisement
Preparing for operation
.
82
2.
Set the parameter with the
Display:
3.
Switch to the second parameter by pressing the operation mode
key
briefly. This has set automatically to 90°.
Display:
4.
Switch on to the following display with the operation mode key
5.
Start initialization by pressing the key
5 seconds.
Display:
During the initialization phase "RUN1" to "RUN5" appear one after
another in the bottom display (see also structograms in figure 49,
page 85 to figure 52, page 88).
NOTE
The initialization process may last up to 15 minutes depending on the
actuator.
The initialization is complete when the following display
appears:
The top value indicates the total angle of rotation of the actuator
(example 93.5°).
key to "turn"
for longer than
SIPART PS2 PA Manual
A5E00127926--05
:
Advertisement
Table of Contents
