Oil Control Valve Removal And Installation; Oil Control Valve Inspection - Suzuki WagonR+ RB310 Service Manual

4
2
(a)
5
3
1
(b)
5
1
2
ENGINE AND EMISSION CONTROL SYSTEM (M13 ENGINE) 6E2-21

Oil control valve removal and installation

Removal
Remove oil gallery pipe No.1 (1) and oil control valve (2) from tim-
ing chain cover (3).
Installation
1) Install new O-ring (4) to oil control valve.
2) Install oil control valve to timing chain cover.
Tighten nuts to specification.
Tightening torque
Oil control valve mounting nuts
(a): 11 N·m (1.1 kg-m, 8.0 lb-ft)
3) Install oil gallery pipe No.1 with new copper washers (5) to
timing chain cover.
Tighten bolts to specification.
Tightening torque
Oil gallery pipe No.1 bolts
(b): 30 N·m (3.0 kg-m, 21.5 lb-ft)

Oil control valve inspection

1) Inspect strainer (1) and mating surface (2) of oil control valve
for clog or damage. Clean oil control valve if clog or foreign
matter is present on strainer or mating surface of oil control
valve.
Replace oil control valve if its mating surface is damaged.
2) Check resistance between terminals of oil control valve.
Resistance: 6.7 – 7.7 Ω (at 20°C (68°F))