Suzuki WagonR+ RB310 Service Manual page 487

3E-12 REAR SUSPENSION
7) Install brake back plates (1) and tighten back plate bolts (2)
to specified torque.
Tightening torque
Brake back plate bolt (a): 23 N
8) Connect wheel speed sensor and lead wire clamps (right &
left) (if equipped).
CAUTION:
Since there are two holes on each side of rear axle, be
sure to install wheel speed sensor at the position as
shown in the figure.
9) Connect brake pipes to wheel cylinders (1) (right & left) and
tighten brake pipe flare nuts (2) to specified torque.
Tightening torque
Brake pipe flare nut (b): 16 N
10) Connect brake flexible hoses (1) (right & left) to bracket on
rear axle and secure it with E-rings (2) (right & left).
11) Install LSPV spring (1) to rear axle (2) (if equipped with
LSPV).
Tightening torque
·
LSPV bolt (a): 26 N m (2.6 kg-m, 19.0 lb-ft)
·
m (2.3kg-m, 16.5 lb-ft)
·
m (1.6 kg-m, 11.5 lb-ft)