Engine Assembly - Subaru Legacy 2005 Service Manual

MECHANICAL

9. Engine Assembly

A: REMOVAL
1) Set the vehicle on a lift.
2) Open the front hood fully and support it with front
food stay.
3) Collect the refrigerant from A/C system. <Ref. to
AC-20, PROCEDURE, Refrigerant Recovery Pro-
cedure.>
4) Release the fuel pressure.
<Ref. to FU(H4SO 2.0)-38, RELEASING OF FUEL
PRESSURE, PROCEDURE, Fuel.> or <Ref. to
FU(H4SO 2.5)-41, RELEASING OF FUEL PRES-
SURE, PROCEDURE, Fuel.>
5) Remove the fuel filler cap.
6) Disconnect the ground cable from battery.
7) Remove the air intake duct, air cleaner case and
air intake chamber.
<Ref. to IN(H4SO 2.0)-8, REMOVAL, Air Intake
Duct.> <Ref. to IN(H4SO 2.0)-5, REMOVAL, Air
Cleaner Case.> <Ref. to IN(H4SO 2.0)-7, REMOV-
AL, Air Intake Chamber.>
8) Remove the under cover.
9) Remove the radiator from vehicle. <Ref. to
CO(H4SO 2.0)-20, REMOVAL, Radiator.>
10) Disconnect the A/C pressure hoses from A/C
compressor.
11) Remove the air intake chamber stay.
Engine Assembly
12) Disconnect the following connectors and ca-
bles.
(1) Front oxygen (A/F) sensor connector
(2) Rear oxygen sensor connector
IN-00203
(3) Engine ground cable
(4) Engine harness connectors
ME-00816
ME(H4SO 2.0)-30
ME-00859
FU-01116
ME-00206
ME-00817