Subaru Legacy 2005 Service Manual page 166

FUEL INJECTION (FUEL SYSTEM)
13) Remove the fuel injectors.
(1) Remove the clip which secures fuel injector
from injector pipe.
(2) Remove the fuel injector while lifting up the
fuel injector pipe.
14) Loosen the clamp which holds fuel injector pipe
LH to fuel hose, and then disconnect the pipe from
fuel hose.
15) Loosen the clamp which holds fuel injector pipe
RH to fuel hose, and then disconnect the pipe from
fuel hose.
16) Remove the fuel injector pipe.
Intake Manifold
17) Remove the bolt which installs fuel pipes on in-
take manifold.
FU-02074
18) Remove the fuel pipe assembly and pressure
regulator from intake manifold.
D: ASSEMBLY
NOTE:
When assembling the nipple, apply liquid gasket.
Liquid gasket:
THREE BOND 1105 (Part No. 004403010)
Tightening torque:
17 N
1) Install the fuel pipe assembly and pressure reg-
ulator to intake manifold.
2) Tighten the bolt which installs fuel pipes on in-
take manifold.
Tightening torque:
FU-02075
6.4 N
FU-02076
FU(H4SO 2.0)-16
⋅
m (1.7 kgf-m, 12.5 ft-lb)
⋅
m (0.65 kgf-m, 4.7 ft-lb)
FU-02077
FU-02077