V-Belt - Subaru Legacy 2005 Service Manual

6. V-belt

A: INSPECTION
1. EXCEPT FOR 3.0 L MODEL
1) Replace the belts if crack, fraying or wear is
found.
2) Check the V-belt tension and adjust it if neces-
sary by changing the generator installing position
or idler pulley installing position. <Ref. to PM-12,
REPLACEMENT, V-belt.>
Belt tension (without belt tension gauge):
(A)
When installing new one: 7 — 9 mm (0.276 —
0.354 in)
At inspection: 9 — 11 mm (0.354 — 0.433 in)
(B)
When installing new one: 7.5 — 8.5 mm (0.295
— 0.335 in)
At inspection: 9.0 — 10.0 mm (0.354 — 0.394
in)
GEN
P/S
(A) Front side belt
(B) Rear side belt
(C) 98 N (10 kgf, 22 lbf)
C/P Crank pulley
GEN Generator
P/S Power steering oil pump pulley
A/C A/C compressor pulley
I/P Idler pulley
(C)
A/C
(A) (B)
I/P
C/P
PM-00272
V-belt
PERIODIC MAINTENANCE SERVICES
Belt tension (with belt tension gauge):
(A)
When installing new one: 640 — 785 N (65.3
— 80.0 kgf, 144 — 176 lbf)
At inspection: 490 — 640 N (50 — 65 kgf, 110
— 144 lbf)
(B)
When installing new one: 620 — 760 N (63 —
77 kgf, 140 — 170 lbf)
At inspection: 350 — 450 N (36 — 46 kgf, 79 —
101 lbf)
(A)
P/S
(A) Front side belt
(B) Rear side belt
C/P Crank pulley
GEN Generator
P/S Power steering oil pump pulley
A/C A/C compressor pulley
I/P Idler pulley
PM-11
A/C
GEN
I/P
C/P
PM-00154
(B)