Management Access - Fortinet FortiGate Series Administration Manual

Operation mode and VDOM management access

Management access

264
2 From the Operation Mode list, select Transparent.
3 Enter the following information and select Apply.
Management IP/Netmask
Default Gateway
To switch from Transparent to NAT/Route mode
1 Go to System > Config > Operation Mode or select Change beside Operation Mode on
the System Status page for the virtual domain.
2 From the Operation Mode list, select NAT.
3 Enter the following information and select Apply.
Interface IP/Netmask
Device
Default Gateway
Gateway Device
You can configure management access on any interface in your VDOM. See
administrative access to an interface" on page
address is used for management access. In Transparent mode, you configure a single
management IP address that applies to all interfaces in your VDOM that permit
management access. The FortiGate also uses this IP address to connect to the FDN for
virus and attack updates (see
Enter the management IP address and netmask.
valid IP address for the network from which you want to
manage the FortiGate unit.
Enter the default gateway required to reach other networks from the
FortiGate unit.
Enter a valid IP address and netmask for the network from which
you want to manage the FortiGate unit.
Select the interface to which the Interface IP/Netmask settings
apply.
Enter the default gateway required to reach other networks from the
FortiGate unit.
Select the interface to which the default gateway is connected.
192. In NAT/Route mode, the interface IP
"Configuring FortiGuard Services" on page
FortiGate Version 4.0 MR1 Administration Guide
System Config
This must be a
"Configuring
322).
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback