Fortinet FortiGate Series Administration Manual page 54

Dynamic routing for IPv6 traffic
54
Variable
stub-type
{no-summary | summary}
type
{regular | stub}
config range Variables
edit <range_id>
advertise
{enable | disable}
prefix6
<address_ipv6mask>
config virtual-link Variables
edit <vlink_name>
dead-interval
<seconds_integer>
hello-interval
<seconds_integer>
peer <address_ipv4>
retransmit-interval
<seconds_integer>
transmit-delay
<seconds_integer>
What's new in FortiOS Version 4.0 MR1
Description
Enter no-summary to prevent an ABR sending
summary LSAs into a stub area. Enter summary
to allow an ABR to send summary LSAs into a
stub area.
Set the area type:
• Select regular for a normal OSPF area.
• Select stub for a stub area.
Enter an ID number for the range. The number
must be an integer in the 0 to 4 294 967 295
range.
Enable or disable advertising the specified
range.
Specify the range of addresses to summarize.
Enter a name for the virtual link.
The time, in seconds, to wait for a hello packet
before declaring a router down. The value of the
dead-interval should be four times the value
of the hello-interval.
Both ends of the virtual link must use the same
value for dead-interval.
The valid range for seconds_integer is 1 to
65535.
The time, in seconds, between hello packets.
Both ends of the virtual link must use the same
value for hello-interval.
The valid range for seconds_integer is 1 to
65535.
The router id of the remote ABR.
0.0.0.0 is not allowed.
The time, in seconds, to wait before sending a
LSA retransmission. The value for the retransmit
interval must be greater than the expected
round-trip delay for a packet. The valid range for
seconds_integer is 1 to 65535.
The estimated time, in seconds, required to
send a link state update packet on this virtual
link.
OSPF increments the age of the LSAs in the
update packet to account for transmission and
propagation delays on the virtual link.
Increase the value for transmit-delay on low
speed links.
The valid range for seconds_integer is 1 to
65535.
FortiGate Version 4.0 MR1 Administration Guide
Default
summary
regular
No default.
enable
::/0
No default.
40
10
0.0.0.0
5
1
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback