Installing The Cable Management Arm - Fortinet FortiMail-100 Install Manual

Installing the cable management arm

Installing the cable management arm
40
Figure 7: Removing the system from the rack
3
2
2 Pull up on each lever into the release position to unlock (2).
3 Grasp the sides of the system firmly and pull forward and up to unseat the system from
the J-slots. Lift the system up and away from the rack and place on a level surface (3).
The FortiMail-2000B unit comes with a cable management arm. Use the instructions
below to install the arm.
Caution: Only trained service technicians are authorized to remove the system cover and
access any of the components inside the system. Before you begin, review the safety
instructions that came with the system.
Note: The illustrations in this document are not intended to represent a specific server.
To install the cable management arm
1 Locate the components for installing the Cable Management Arm (CMA) assembly:
• Cable Management Arm tray (1)
• Cable Management Arm (2)
• Nylon cable tie wraps (3)
FortiMail™ Secure Messaging Platform Version 4.0 Patch 1 Install Guide
FortiMail-2000B hardware installation
1
Revision 2
http://docs.fortinet.com/ • Feedback