Configuring Dhcp For Your Wireless Lan; Configuring Firewall Policies For The Wireless Lan; Monitoring Wireless Clients; Monitoring Rogue Aps - Fortinet FortiGate Series Administration Manual

Wireless Controller

Configuring DHCP for your wireless LAN

Configuring firewall policies for the wireless LAN

Monitoring wireless clients

Monitoring rogue APs

FortiGate Version 4.0 MR1 Administration Guide
01-410-89802-20090903
http://docs.fortinet.com/ • Feedback
Go to System > DHCP > Service to configure DHCP services to provide IP addresses to
your wireless clients. See
For your VAP clients to communicate with other networks, including other wireless LANs,
you must have appropriate firewall policies. Your VAP has a virtual interface of the same
name that you can select as the source or destination interface in firewall policies.
Go to Wireless Controller > Wireless Client to view information about the wireless clients
of your managed access points.
IP
Physical AP
Virtual AP
Signal Strength/Noise
Rx (KBytes)
Tx (KBytes)
Clients list (AP mode)
MAC Address
IP Address
AP Name
Go to Wireless Controller > Rogue AP to view information about detected APs.
Refresh Interval Set time between information updates. none means no updates.
Refresh Updates displayed information now.
Inactive Access Points Select which inactive access points to show: all, none, those detected
less than one hour ago, or those detected less than one day ago.
Online A green checkmark indicates an active access point. A grey X indicates
that the access point is inactive.
SSID The wireless service set identifier (SSID) or network name for the
wireless interface.
MAC Address The MAC address of the Wireless interface.
Signal Strength /Noise The signal strength and noise level.
Channel The wireless radio channel that the access point uses.
Rate The data rate of the access point.
First Seen The data and time when the FortiWifi unit first detected the access point.
"Configuring DHCP services" on page
The IP address assigned to the client.
The name of the physical access point with which the client is
associated.
The name of the virtual access point with which the client is
associated.
The signal-to-noise ratio in deciBels calculated from signal
strength and noise level.
The amount of data in kilobytes received this session.
The amount of data in kilobytes sent this session.
Real-time details about the client wireless devices that can
reach this FortiWiFi unit access point. Only devices on the
same radio band are listed.
The MAC address of the connected wireless client.
The IP address assigned to the connected wireless client.
The name of the wireless interface that the client is connected
to.
Configuring DHCP for your wireless LAN
228.
707