Removing The System From The Rack; Cable Management Arm Installation - Fortinet FortiManager-1000C Rack And Hardware Install Manual

Cable Management Arm Installation

Removing the system from the rack

Cable Management Arm Installation
14
To remove the system from the rack
1 Pull the system out of the rack until the sliding rails lock into place (1).
Figure 9: Removing the system from the rack
2
2 Locate the white tabs on the sides of the chassis rail members (2).
3 Pull the tabs towards the front of the system to release the chassis rail members from
the rails. Continue pulling the system until the chassis rail members are completely
clear of the rails and place the system on a level surface (3).
The FortiManager-1000C comes with a Cable Management Arm. Use the instructions
below to install the Cable Management Arm.
Caution: Only trained service technicians are authorized to remove the system cover and
access any of the components inside the system. Before you begin, review the safety
instructions that came with the system.
Note: The illustrations in this document are not intended to represent a specific server.
3
FortiManager-1000C™ Version 4.0 Rack and Hardware Install Guide
Rack Installation Instructions
1
02-40000-112634-20091026
http://docs.fortinet.com/ • Feedback