X-Slot Connections; Installing Accessories; Initial Startup - Powerware 9390 Installation & Operation Manual

3.2.4.3 X-Slot Connections

For installation and set up of an X-Slot card, please contact Powerware (see page 1-4).
To install wiring for connections:

3.2.5 Installing Accessories

To install optional accessories, see Chapter 5, "Installing a Remote Emergency Power-Off
Control."

3.3 Initial Startup

Startup and operational checks must be performed by an authorized Powerware Customer
Service Engineer, or the warranty terms, as specified on page W-1, will be void. This service
is offered as part of the sales contract for the UPS. Contact service in advance (usually a
two week notice is required) to reserve a preferred startup date.
Powerware 9390 UPS (40–80 kVA) Installation and Operation Manual S 164201535 Rev A
®
NOTE LAN and telephone drops for use with X-Slot connectivity cards must be
provided by facility planners or customer.
NOTE When installing wiring to X-Slot cards, you must install conduit to the UPS
cabinet.
1. If not already installed, install the LAN and telephone drops.
2. Unfasten the front door latch and swing the door open.
3. Remove the UPS cabinet X-Slot wire entry conduit landing plate to drill or punch
conduit holes (see Drawing 164201535-6 on page A-14).
4. Reinstall conduit landing plate and install conduit.
5. Route and install LAN, telephone, and other cables to appropriate X-Slot cards.
6. Close door and secure with latch.
7. Refer to the manual supplied with the X-Slot card for user instructions.
Installing the UPS System
3-9