Powerware 9390 Installation & Operation Manual page 20

Installing the UPS System
1. If not already accomplished, use a forklift or other material handling equipment
NOTE Verify that the forklift or pallet jack is rated to handle the weight of the cabinet
(see Table A on page A-3 for cabinet weight).
2. Unfasten front door latch and swing door open. (see Figure 3-1).
3. If the leveling feet are not fully retracted, turn the leveling feet until they are
4. Remove three bolts (2), in Figure 3-2, securing the rear shipping bracket (3) to the
5. Remove three bolts (2), in Figure 3-1, securing the front anti-tip/shipping
6. Remove three bolts (4), in Figure 3-2, securing removable skid (5) and remove
NOTE In the following step the pallet will tilt and act as a ramp once the cabinet is
rolled beyond the the center of the pallet. Make sure to restrain the cabinet as it
continues to roll down the pallet/ramp.
Do not stand directly behind the pallet while unloading the cabinet. If unloading instructions
are not closely followed, the cabinet may cause serious injury.
7. Slowly roll the cabinet toward the rear of the pallet. Once the pallet tilts, continue
8. Roll cabinet to final installation location.
9. If installing cabinet permanently, retain shipping brackets and hardware;
10. If permanently mounting the system, proceed to Step 14; otherwise, proceed to
11. Secure the UPS cabinet in position by lowering the leveling feet, until cabinet is
3-2
to move the cabinet to the installation area, or as close as possible, before
unloading from the pallet. Insert the forklift jacks between the skids on the
bottom of the unit.
retracted.
cabinet and two bolts (1) securing the bracket to the pallet. Remove the rear
shipping bracket. If installing cabinet permanently, retain shipping bracket and
securing hardware for later use.
bracket (3) to the cabinet and two bolts (1) securing the bracket to the pallet.
Remove the front ant-ship/shipping bracket. Retain front anti-tip/shipping bracket
and securing hardware for later use. Do not discard front anti-tip/shipping
bracket. This bracket is required for installation.
skid.
rolling the cabinet down the pallet until the cabinet is clear of the pallet.
otherwise, discard or recycle the pallet and rear bracket in a responsible manner.
Step 11.
not resting on the casters and the cabinet is level.
Powerware 9390 UPS (40–80 kVA) Installation and Operation Manual S 164201535 Rev A
®
W A R N I N G