Task Overview - Siemens Hicom Office PhoneMail Supplement To The Installation And System Administration Manual

Table 3-2 notes the purpose of each component shown in Figure 3-1 on page 3-2..
Component
Service access port
Status indicator
Software load/Diagnostic button
Digital station connector
On/off switch
Card slot
Card ejection button
Table 3-2 Purpose of Components
3.3

Task Overview

To install the HOP E board into your existing Hicom CS:
1. Connect the adaptor cable to the service access port of the HOP E board.
2. Install the HOP E board with the attached adaptor cable into the Hicom CS.
3. Run the adaptor cable through the Hicom CS.
A31003-S1220-D300-3-76D1, March 2000
HOP/HOP E, Version 2.0, Supplement to the Installation and System Administration Guide
Installing a New HOP E Board into an Existing Hicom CS
Purpose
To connect the adaptor cable
To indicate the operating state of the HOP system
To load new software or languages
To connect the HOP E board with the Hicom CS
To turn the HOP system on and off
To insert HOP cards
To eject HOP cards
4890_ecd.fm
Task Overview
3-3