Unlocking The Scanner - Microtek ArtixScan M2 Getting To Know Manual

Before you can operate the scanner, you will need to unlock the scanner. To unlock
the scanner, follow the steps below:
1. Remove the yellow "Step 3" sticker
2. Look for the unlocking screw at the
3. Using a screwdriver, push and turn
Shipping the Scanner
If you have to transport the scanner, you will need to lock the scanner back. Follow
the steps below:
1. Turn off the scanner if your scanner
2. Turn the scanner back on. The
3. When the indicators on the front of
4. Turn off your scanner. The scanner is now ready for transport.
4 ArtixScan M2 Supplement

Unlocking the Scanner

from your scanner.
bottom of the scanner.
the locking screw counterclockwise
to the unlock position.
When successfully unlocked, the
screw will push out a little,
protruding slightly from the bottom
of the scanner.
is on.
scanner's carriage will move to the
standby position in 5 minutes.
your scanner stop blinking, use a
screwdriver, and then push and turn
the locking screw clockwise to the
locked position.
When the screw has been tightened, this indicates that your scanner is locked.