Microtek ArtixScan M2 Getting To Know Manual page 6

Positioning Transparent Film
This procedure applies when you use the lower scan bed of the ArtixScan M2.
There are two ways to scan transparent film:
A. By using the Glass Holder to scan non-standard-size transparent film.
B. By using the Main Holder, which is used together with individual film holders to
35mm slides Holder
Main Holder
6 ArtixScan M2 Supplement
Glass Holder
Important:
When using the Main Holder or the Glass Holder, make sure you use the correct
side up when inserting the holders into the scanner. The correct side up is the
side showing the holder labels facing up.
Make sure that the calibration strip on the holders are kept clear and free of
obstruction at all times; no material should ever be placed on this area. Also, make
sure the calibration strip faces the front of the scanner when you insert the
holders into the lower compartment of the ArtixScan M2.
scan standard-size transparent film, such as 35mm slides, 35mm filmstrips, 6 x 4.5-
cm, 6 x 6-cm, 6 x 7-cm, 6 x 9-cm, 6 x 17-cm, 6 x 22-cm, or 4" x 5" films.
Calibration strip
Vinyl strip
Calibration strip