Using The 4 " X 5 " Film Holder - Microtek ArtixScan M2 Getting To Know Manual

D. Using the 4 " x 5 " Film Holder
The 4" x 5" Film Holder can hold two pieces of 4" x 5" film at a time.
1. Place the 4" x 5" film to be scanned inside the 4" x 5" Film Holder, as indicated in
a) Push on the side to
open the lid.
2. Put the 4" x 5" Film Holder into the Main Holder.
3. Insert the whole assembly into the transparency bay of the scanner.
12 ArtixScan M2 Supplement
the graphic below. The shiny base of the 4" x 5" film should be facing down.
b) Place the film face
Make sure that the red arrow
marks on both the 4" x 5"
Film Holder and the Main
Holder are pointing to each
other when the holders are
put together
down into the holder.
c) Pull down the side
to close the lid.