Positioning The Transparent Target - Microtek ArtixScan M2 Getting To Know Manual

Positioning the Transparent Target

Proper positioning of the target on the scanner is important for successful calibration.
Incorrect positioning of the target will result in an unsuccessful calibration.
1. Place the transparent target face down into the 4" x 5" Film Holder; orientation of
the target is critical. Make sure that the side of the target (with the woman's
portrait) is at the right side of the scanner — where the Kodak logo is positioned
at the upper-right corner.
Refer to the section "D. Using the 4" x 5" Film Holder" of this manual to load the
film.
2. Place the holder with transparent target into the Main Holder, then put this
assembly in the transparency bay of the scanner.
Make sure the woman's
portrait lies towards the
right side of the scanner
ArtixScan M2 Supplement 31