Using The 6 X 22-Cm (120) Film Holder - Microtek ArtixScan M2 Getting To Know Manual

C. Using the 6 x 22-cm (120) Film Holder
The 6 x 22-cm (120) Film Holder can hold up to four pieces of 6 x 4.5-cm film, 2 pieces
of 6 x 9-cm film, or a single piece of 6 x 17-cm film.
1. Place the film to be scanned into the 6 x 22-cm (120) Film Holder, as indicated in the
graphic below. The shiny base of the film should be facing down.
a) Push on the side to
open the lid.
2. Put the 6 x 22-cm (120) Film Holder into the Main Holder.
Make sure that the red
arrow marks on both the 6
x 22-cm Film Holder and
the Main Holder are
pointing to each other
when the holders are put
together
3. Insert the whole assembly into the transparency bay of the scanner.
b) Place the film face
down into the holder.
c) Pull down the side
to close the lid.
ArtixScan M2 Supplement 11