Toro Workman 07390 Operator's Manual page 42

1. Note the clearance between the fill device and the oil-fill
neck.
Important:
When adding engine oil or filling
oil, there must be clearance between the oil
fill device and the oil fill neck in the valve
cover as shown in
is necessary to permit venting when adding
oil.
8. Install the filler cap onto the filler neck
42).
9. Firmly install the dipstick
Changing the Engine Oil and Filter
Service Interval: After the first 50 hours
Every 200 hours
1. Raise the bed and place the safety support on
the extended lift cylinder to hold up the bed.
2. Align a large drain pan under the oil-drain plug
(Figure 44).
Figure 43
Figure 43. This clearance
(Figure 42).
1. Drain plug
2. Forward
g002373
3. Remove the drain plug and let the oil flow into a
drain pan
4. When the oil stops draining, install the drain
plug.
5. Remove the oil filter from the filter adapter
(Figure
(Figure
1. Forward
2. Oil filter
6. Wipe clean the sealing base of the of the filter
adapter
7. Apply a light coat of clean oil to the seal of the
new filter.
8. Install the filter until the gasket contacts the
sealing base of the filter adapter, then tighten
the filter clockwise and additional 1/2 to 2/3 of
a turn
Note:
42
Figure 44
(Figure 44).
45).
Figure 45
3. Filter adapter
(Figure 45).
(Figure 45).
Do not overtighten the engine-oil filter.
g025525
g025524