Toro Workman 07390 Operator's Manual page 33

Maintenance Service
Interval
Before each use or daily
Every 25 hours
Every 50 hours
Every 100 hours
Every 200 hours
Every 400 hours
Every 800 hours
Every 1,000 hours
Every 2,000 hours
Yearly
Maintenance Procedure
• Inspect the seat belt(s) for wear, cuts, and other damage. Replace the seat belt(s) if
any component does not operate properly.
• Check the tire pressure.
• Check the operation of the safety-interlock system.
• Check the engine-oil level. (Check the oil level before and after the engine is first
started and daily thereafter.)
• Check the oil-pressure-warning light.
• Check the level of the coolant. Check the Coolant level at the overflow reservoir
only. Do not remove the radiator cap. (Check the coolant level before the engine is
first started and daily thereafter.)
• Remove debris from the engine area and radiator. (Clean it more frequently in
dirty conditions.)
• Check the brake-fluid level. (Check the level before the engine is first started and
daily thereafter.)
• Check the hydraulic-fluid level. (Check the level of hydraulic fluid before the engine
is first started and daily thereafter.)
• Wash the machine.
• Remove the air-cleaner cover and clean out the debris.
• Check the battery-fluid level (every 30 days if in storage).
• Check the battery cable connections.
• Grease the bearings and bushings (lubricate more frequently in heavy-duty
applications).
• Change the air-cleaner filter (more frequently in dusty or dirty conditions).
• Check the spark plugs.
• Inspect the condition of the tires.
• Check the constant-velocity boots for damage and leaking lubricant.
• Change the engine oil and filter.
• Change the carbon canister air filter.
• Torque the front and rear wheel nuts
• Check the fluid level in the reservoir for the speed-control cylinder.
• Check the adjustment of the parking brake.
• Check the adjustment of the brake pedal.
• Inspect the service and parking brakes.
• Replace the fuel filter.
• Inspect the fuel lines and connections.
• Check the front wheel alignment.
• Check the transmission-fluid level.
• Check the condition of the drive belt.
• Clean the clutches.
• Visually inspect the brakes for worn brake shoes.
• If you are not using the recommended hydraulic fluid or have ever filled the reservoir
with an alternative fluid, replace the hydraulic fluid and filter.
• Flush/replace the coolant system fluid.
• Change the brake fluid.
• If you are using the recommended hydraulic fluid, replace the hydraulic filter.
• If you are using the recommended hydraulic fluid, change the hydraulic fluid.
• Complete all of the yearly maintenance procedures specified in the engine owner's
manual.
33