Storage; Storage Safety; Storing The Machine - Toro Workman 07390 Operator's Manual

Storage

Storage Safety

•
Shut off the machine, remove the key (if equipped),
and wait for all movement to stop before you leave
the operator's position. Allow the machine to cool
before adjusting, servicing, cleaning, or storing it.
•
Do not store the machine or fuel container where
there is an open flame, spark, or pilot light, such
as on a water heater or other appliance.

Storing the Machine

Service Interval: Every 200 hours—Inspect the
service and parking brakes.
Every 400 hours—Visually inspect the brakes
for worn brake shoes.
Yearly
1. Position the machine on a level surface, engage
the parking brake, shut off the engine, and
remove the key from the key switch.
2. Clean dirt and grime from the entire machine,
including the outside of the engine cylinder head
fins and blower housing.
Important:
You can wash the machine
with mild detergent and water. Do not
use high-pressure water to wash the
machine. Pressure washing the machine
may damage the electrical system or wash
away necessary grease at friction points.
Avoid excessive use of water, especially near
the control panel, lights, engine, and battery.
3. Check and adjust the brake pedal and parking
brake, if necessary; refer to
Pedal (page 57)
Brake (page 56).
4. Service the air cleaner; refer to
Filter (page 40).
5. Grease the machine; refer to
Bearings and the Bushings (page
6. Change the engine oil and filter; refer to
Servicing the Engine Oil (page
7. Check the tire pressure; refer to
Tire Pressure (page
8. For storage over 30 days, prepare the fuel
system as follows:
A. Add a petroleum based
stabilizer/conditioner to the fuel in the
tank. Do not use an alcohol-based stabilizer
(ethanol or methanol).
Important:
stabilizer/conditioner longer than the
Adjusting the Brake
and Adjusting the Parking
Servicing the Air
Greasing the
39).
41).
Checking the
21).
Do not store fuel containing
duration recommended by the fuel
stabilizer manufacturer.
B. Run the engine to distribute conditioned fuel
through the fuel system for 5 minutes.
C. Shut off the engine, allow it to cool, and
drain the fuel tank.
D. Start the engine and run it until it stops.
E. Start and run the engine again until it does
not start again.
F. Dispose of drained fuel properly. Recycle
as per local codes.
9. Remove the spark plugs and check their
condition; refer to
(page 43).
10. With the spark plugs removed from the engine,
pour 15 ml (2 tablespoons) of engine oil into the
spark-plug hole.
11. Use the starter to crank the engine and distribute
the oil inside the cylinder.
12. Install the spark plugs and tighten each one to
the recommended torque; refer to
Spark Plugs (page
Note:
Do not install the spark-plug wires on the
spark plugs.
13. Check the anti freeze protection and add a 50/50
solution of water and anti freeze as needed for
expected minimum temperature in your area.
14. Remove the battery from the chassis, and
charge it fully; refer to
(page 47).
Note:
Do not connect the battery cables to the
battery posts during storage.
Important:
charged to prevent it from freezing and being
damaged at temperatures below 0°C (32°F).
A fully charged battery maintains its charge
for about 50 days at temperatures lower
than 4°C (40°F). If the temperatures will be
above 4°C (40°F), check the water level in the
battery and charge it every 30 days.
15. Check and tighten all fasteners. Repair or
replace any part that is damaged.
16. Paint all scratched or bare metal surfaces
with paint available from your authorized Toro
distributor.
17. Store the machine in a clean, dry garage or
storage area.
18. Remove the key from the key switch and put it in
a safe place that is out of the reach of children.
19. Cover the machine to protect it and keep it clean.
65
Servicing the Spark Plugs
Servicing the
43).
Servicing the Battery
The battery must be fully