Removing Debris From The Cooling System - Toro Workman 07390 Operator's Manual

2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Check the coolant level at the reserve tank
(Figure 67).
Note:
The coolant should be up to the bottom
of the filler neck.
Figure 67
1. Coolant-reserve tank
5. If coolant is low, remove the reserve- tank cap
and add a 50/50 mixture of water and permanent
ethylene-glycol antifreeze.
Note:
Do not overfill.
6. Install the reserve-tank cap.
Removing Debris from the
Cooling System
Service Interval: Before each use or daily—Remove
1. Park the machine on a level surface.
2. Engage the parking brake.
3. Shut off the engine and remove the key.
4. Clean the engine area thoroughly of all debris.
5. Unlatch and remove the radiator screen from the
front of the radiator
1. Radiator screen
2. Latch
g019522
6. If equipped, rotate the latches and pivot the oil
cooler away from the radiator
1. Radiator housing
2. Oil cooler
7. Clean the radiator, oil cooler, and screen with
compressed air.
Note:
Blow debris away from the radiator.
8. Install the cooler and screen to the radiator.
54
debris from the engine area and
radiator. (Clean it more frequently in
dirty conditions.)
(Figure 68).
Figure 68
(Figure
Figure 69
3. Latches
g010315
69).
g010316