Operating The Cargo Bed - Toro Workman 07390 Operator's Manual

Rollover Protection System
(ROPS) Safety
•
The ROPS is an integral safety device.
•
Do not remove the ROPS from the machine.
•
Always wear your seat belt; ensure that it is
attached and that you can release it quickly in an
emergency.
•
Check carefully for overhead obstructions and do
not contact them.
•
Keep the ROPS in safe operating condition by
thoroughly inspecting it periodically for damage
and keeping all the mounting fasteners tight.
•
Replace damaged ROPS components. Do not
repair or alter them.
Slope Safety
Slopes are a major factor related to loss-of-control
and tip-over accidents, which can result in severe
injury or death.
•
Survey the site to determine which slopes are
safe for operating the machine and establish your
own procedures and rules for operating on those
slopes. Always use common sense and good
judgment when performing this survey.
•
If you feel uneasy operating the machine on a
slope, do not do it.
•
Keep all movement on slopes slow and gradual.
Do not suddenly change the speed or direction of
the machine.
•
Avoid operating the machine on wet terrain. Tires
may lose traction. A rollover can occur before the
tires lose traction.
•
Travel straight up and down a slope.
•
If you begin to lose momentum while climbing a
slope, gradually engage the brakes and slowly
reverse the machine straight down the slope.
•
Turning while going up or down a slope can be
dangerous. If you must turn on a slope, do it slowly
and cautiously.
•
Heavy loads affect stability on a slope. Carry a
reduced load and reduce your ground speed when
operating on a slope or if the load has a high
center of gravity. Secure the load to the cargo bed
of the machine to prevent the load from shifting.
Take extra care when hauling loads that shift easily
(e.g., liquids, rock, sand, etc.).
•
Avoid starting, stopping, or turning the machine
on a slope, especially with a load. Stopping while
going down a slope takes longer than stopping
on level ground. If you must stop the machine,
avoid sudden speed changes, which can cause
the machine to tip or roll over. Do not engage the
brakes suddenly when rolling rearward, as this
may cause the machine to overturn.
Loading and Dumping Safety
•
Do not exceed the gross vehicle weight (GVW)
of the machine when operating it with a load in
the cargo bed and/or towing a trailer; refer to
Specifications (page
•
Distribute the load in the cargo bed evenly to
improve the stability and control of the machine.
•
Before dumping, ensure that there is no one
behind the machine.
•
Do not dump a loaded cargo bed while the
machine is sideways on a slope. The change
in weight distribution may cause the machine to
overturn.

Operating the Cargo Bed

Raising the Cargo Bed
WARNING
A raised bed could fall and injure persons that
are working beneath it.
• Always use the prop rod to hold the bed up
before working under the bed.
• Remove any load material from the bed
before raising it.
WARNING
Driving the machine with the cargo bed raised
could cause the machine to tip or roll easier.
You could damage the structure of the cargo
bed if you operate the machine with the bed
raised.
• Operate the machine when the cargo bed
is down.
• After emptying the cargo bed, lower it.
25
20).