Driving The Machine; Stopping The Machine; Shutting Off The Engine; Using The Speed-Range Control - Toro Workman 07390 Operator's Manual

continuous cranking, wait 60 seconds before
engaging starter motor again.

Driving the Machine

1. Press the brake pedal.
2. Disengage the parking brake.
3. Move the transmission lever to the desired gear.
4. Release the service brake and gradually press
in the accelerator pedal.
Important:
Always stop the machine before
shifting to reverse a forward gear or to a
forward gear from reverse.
Use the chart below to determine the ground
speed of each gear when operating the
machine with the speed-range control in the T
(T ) position.
RANSPORT
Gear Speed (km/h)
R (R ) 0 to 21
EVERSE
L (L F ) 0 to 18
OW ORWARD
D (D ) 0 to 32
RIVE
Note:
Avoid idling the engine for long periods
of time.
Note:
Leaving the key switch in the O
for long periods of time without starting the
engine discharges the battery.

Stopping the Machine

To stop the machine, remove your foot from the
accelerator pedal, then press the brake pedal.

Shutting Off the Engine

1. Stop the machine.
2. Move the transmission lever to the P (P
position.
3. Engage the parking brake.
4. Rotate the key switch to the O
remove the key.
Using the Speed-Range
Control
Use the lever of the speed-range control to limit the
maximum ground speed of the machine for operations
that require a constant speed like spraying and top
dressing. The speed-range lever
to select 1 of the 4 work-speed ranges that are used
to limit maximum ground speed or a transport-speed
range that is used when you move the machine
between job sites.
Note:
order to shift between speed ranges, but you do not
need to stop the machine in order to shift.
•
•
Speed (mph)
0 to 13
0 to 11
Note:
0 to 20
maximum ground speed in each range by 4 to 18
km/h (2.5 to 11 mph) with the transmission lever in
the L (L
20 mph) with the transmission lever in the in the D
(D
position
N
)
ARK
position and
FF
27
You must release the accelerator pedal in
Move the speed-range lever into the detent for
speed ranges A, B, C, and D when precise control
of maximum-ground speed is desired.
Move the speed-range lever to the T (T
position by moving the speed-range lever out of
the detent for range A, B, C, or D, then forward to
the T (T ) position.
RANSPORT
Use the speed-range control to limit the
F ) position or 8 to 32 km/h (5 to
OW ORWARD
) position.
RIVE
Figure 23
1. Speed-range lever
2. T (transport range)
3. D (high range)
(Figure 23) is used
RANSPORT
g024320
4. C (mid-high range)
5. B (mid-low range)
6. A (low range)
)