GE CDT865SxJ0 Series Technical Service Manual page 84

Drain Pump Removal or Replacement
1. Remove power to the dishwasher.
2. Remove the door (see Door Removal in the
Door section of this service guide).
3. Remove the sump assembly (see the Sump
Module Removal section of this service guide).
4. To remove the harness connector, press in on
the tab, then pull to remove the connector.
5. Loosen or remove the Drain Pump Hanger.
6. Loosen the hose clamp and discard, remove or
replace the drain pump.
Mounting Screw
Grommet
Bracket
Drain
Pump
Clamp
7. Use a new clamp (included with a new pump or
clamp kit WD35X10382 when reinstalling).
When reassembling, position the hose properly onto
the locating feature on the sump.
– 84 –