Top Control Console Cover; Outer Door Panel; Hinges - GE CDT865SxJ0 Series Technical Service Manual

Top Control Console Cover

Top Control Console Cover Removal
1. Remove and separate the door.
2. Remove the bottom cover, UI, light pipe and
buttons.
3. Remove the top console and cover as an
assembly. There are six 1/4 in. hex head screws,
securing the assembly to the inner door (note
the length of the screws). A new cover should
be replaced in the event the cover is loose or
must be removed. The tabs are likely to break on
removal.
Six 1/4 in. hex
head screws
New Top Cover Installation
1. The top cover is secured with sixteen tabs, and
the console has cutouts or slots to allow the top
cover to click lock together.
2. Position the tabs on the cover into the slots on
the console.
3. Press the top and console securely together and
slide the parts to engage the tabs into the slots.
Start from one end and work across to the other
as the cover and console snap together.

Outer Door Panel

Components
Handle Brackets
Bar Handle
The Bar Handle is attached to the outer door panel.
The handle is an assembly with end caps pre-
attached.
Bar Handle Removal
1. Remove and separate the door.
2. Remove two 3/8 in. hex head, 1/4 -28 thread size
screws holding the handle.

Hinges

To remove hinges from the outer door panel,
remove six 1/4 in. hex head screws.
– 35 –
Lens
Handle
Handle Screws
Hinge Screws
Hinges
Badge