GE CDT865SxJ0 Series Technical Service Manual page 30

8. Slide the cable into the cable clip to prevent the
10. Standing in front of the dishwasher, open the
spring from disconnecting from the cable.
door a few inches, then lift the door and hinge
Caution: If the cable is released before it is
secured in the clip, the spring and cable may
become disconnected. Depending on the model
and installation, reconnecting may require the
dishwasher to be removed from the installation.
The cable seated correctly into the clip is shown
below.
9. Repeat steps 5 through 8 on the opposite side.
NOTE: When installing the door onto the dishwasher,
make sure the hinge pins are located on the hinge
– 30 –