Upper Rack - GE CDT865SxJ0 Series Technical Service Manual

Upper Rack

Full Extension Rails Removal
1. Extend to the full outward position.
2. Push up on the right side track lever and down
on the left side lever.
3.
When reinstalling the rack, guide the tracks onto the
rails and push it all the way in to lock it in place.
Rails: The rails are attached to the stainless steel
tub and are a non-replaceable part.
Tracks: Removal of the tracks from the upper rack is
accomplished by removing the one 1/4 in. hex head
screw from the front of the adjustable bracket.
Remove 1/4" hex
head screw
Pull out 1/2 in. and slide the rail toward the front of
the rack, releasing the rail from the rear tab.
1
Viewed from above
Adjustable Bracket
To remove the adjustable rack bracket from the rack
bracket:
1. Remove the rack and rail.
2. Place the rack on a protective surface, upside
down.
3. Push in on the adjusting lever to slide it all the
way down.
4.
rack bracket.
– 24 –
2
(Continued next page)